Bissell Pet Hair Eraser Guide de l'utilisateur télécharger pdf (Page 11)

www.bissell.com

11

Maintenance and care

5. The pre-motor filter can be washed in cold

water with a mild detergent. Rinse well and

air dry thoroughly before placing back into

the tray.

6. Place the tray back into the vacuum

and replace the filter door by inserting

the tabs at the top of the door and

pushing down until it clicks into the

locked position.

Cleaning the post-motor filter*

The post-motor filter is a HEPA media

filter,* which assists in the filtration

process to return clean air to the

room.

1. Turn the power OFF. Unplug the vacuum

from the electrical outlet.

2. The post-motor filter is located behind

the door labeled “FILTER” on the rear of

the vacuum. Open the door by pushing

down on the tab of the door and pulling

out to remove.

3. Remove the post-motor HEPA media filter*

by grasping the handle on the filter and

pulling out to remove.

4. Replace the post-motor HEPA media

filter* with a new filter.

NOTE: The post-motor filter* is a

white, pleated HEPA media filter.*

This filter is NOT washable and must

be replaced when it becomes dirty.

5. Replace the filter door by inserting the

two tabs at the bottom of the filter door.

Then push down on the tab on the

door and push it back into the vacuum.

Release the tab on the door to lock into

place.

Tip:

For maximum cleaning

performance, check the

filters often and clean or

replace if necessary.

WARNING:

Do not operate cleaner with

damp or wet filters or

without all filters in place.

Cleaning the pre-motor filter continued

Post-Motor HEPA

Media Filter*

2.

3.

*The filter media, not the vacuum as a whole,

complies with the IEST-RP-CC001.5 HEPA Standard.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire