Bissell Lift-Off Guide de l'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Use only BISSELL Style 8 Replacement Filters in your
BISSELL Lift-Off
TM
.
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from dirt particles. It
is located in the slide out tray underneath the Dirt Container.
If the filter becomes dirty, pull out the tray, lift out the filter
and clean. This filter may be hand washed in cold water
with mild detergent. Rinse well and air dry thoroughly
before replacing.
The HEPA Media Post-Motor Filter assists in the filtra
-
tion process to return clean air to the room. It is located
behind the door on the back of the cleaner. If the filter
becomes dirty, open the door, remove the filter and
replace. The HEPA Media Filter is not washable.
Check your vacuum cleaners Rotating Floor Brush
and Drive Belt regularly for wear or damage. Make
sure the brush and brush ends are free of debris such
as strings, hair, and carpet fibers. These can wrap
around the brush and hamper its ability to effectively
clean your carpet. Also remove any debris that has
accumulated under the brush cover.
Unplug cleaner from electrical outlet.
Remove Detachable Canister from vacuum cleaner.
Recline Handle and turn vacuum cleaner over so bottom
side is up.
Remove the six screws as shown with a Phillips
head screwdriver. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor
brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or
stressed areas.
Check Air Passageway for obstructions. Remove debris
from this area.
1.
Cleaning The Pre-Motor and Post-Motor Filters
11
1.
2.
3.
2.
3.
4.
5.
6.
7.
8.
9.
Pre-Motor Filter
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
Caution:
To reduce the risk of
injury from moving
parts, turn off vacuum
cleaner and disconnect
Power Plug from
electrical outlet.
Air
Passageway
Motor
Pulley
Check Rotating Brush and Drive Belt
HEPA Media
Post-Motor Filter
Full Line
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire