Bissell 7636 Guide de l'utilisateur télécharger pdf (Page 10)

10

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

Cleaning the pre-motor filter

The pre-motor filter should be checked

often and washed as needed to maintain

performance. More or less frequent

cleaning may be required based on

individual vacuuming habits and types of

debris picked up.

1.

Unplug the vacuum from electrical

outlet.

2. The pre-motor filter protects the

motor from dirt particles. It is located in the

slide out tray underneath the dirt container. If

the filter becomes dirty, pull out the tray, lift

out the foam filter pad and clean it.

Note: The pre-motor filter may be

hand washed in cold water with mild

detergent. Rinse well and air dry

thoroughly before replacing.

Replacing the HEPA media filter cartridge

The post-motor HEPA media filter assists in

the filtration process to return clean air to

the room. It is located under the pre-motor

filter tray. Unit must be detented to locate

the post-motor HEPA media filter.

The HEPA media filter cartridge should be

replaced if machine performance is

noticeably declining. More or less frequent

replacing may be required based on

individual vacuuming habits and types of

debris picked up.

1.

Detent the vacuum.

2. While holding the handle at a 60° angle,

push the button on the top of the HEPA

media filter door to unlatch. Remove the

door. HEPA media filter door is located

directly below the pre-motor filter drawer.

3. If the filter is dirty, remove it and replace

with a new filter.

4. Replace the HEPA media filter door.

Note: The post-motor HEPA media

filter is a white, pleated filter. This

filter is not washable and must be

replaced when it becomes dirty.

Maintenance and care

2

2

WARNING:

Do not operate cleaner

with damp or wet filters

or without all filters in

place.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire